Every corner has a style and a radius. Dragging a dot sets the radius. The style is in the corner’s menu.
Open a corner’s menu
Right-click a corner’s dot.
The menu is named for the corner, such as Top Left. A drawn path's corners are numbered instead, Corner 1, Corner 2 and so on.
Press Escape or click outside it to close it.
Pick a style
The four buttons, left to right:
| Style | What the corner becomes |
|---|---|
| Round | A curve. |
| Chamfer | A straight cut across the corner. |
| Notch | A curve bitten inward, like the corner of a ticket. |
| Square | Sharp again. The radius is kept, so picking another style brings it back. |
Click a style to give it to this corner. Cmd-click it (Ctrl-click on Windows) to give it to every corner.
Here a square photo gets Chamfer on every corner with one Cmd-click. A Cmd-drag on a dot then makes all four cuts bigger at once, and the photo becomes a stop sign.
If the corner was sharp, picking Round, Chamfer or Notch also gives it a starting radius: about a third of the most it can take.
Type an exact radius
The Radius bar sets this corner’s radius in pixels. Drag along it, or double-click it and type a number, then press Enter. It goes up to the most this corner can take.
The radius is in pixels as the shape shows in the comp, whatever the layer’s Scale.
How big a corner can get
A corner’s radius stops at half of its shorter side. Two full corners on the same side meet in the middle, so a full Round on all four corners of a long rectangle makes a pill, and two full Chamfers on one side make a point.
When a shape later gets smaller, for example while its Size animates, a corner that no longer fits shrinks with it and grows back when there’s room.