Progress moves everything

Progress on the Conga null says where the front of the line is, in percent of the path’s length. Every layer reads it, so one slider moves the whole line.

  1. Select the Conga null and find the Conga effect in Effect Controls.
  2. Set a keyframe on Progress where the line should start.
  3. Move the playhead and set Progress where it should stop.

The line travels between the two, every layer the same distance apart the whole way. Ease the keyframes as you would any other.

With Loop off, a layer that runs past either end of the path waits there. With Loop on, it comes round from the other end, and Progress can go past 100 for another lap. See Spacing, Orient and Loop.

Drag it in the panel

Drag the blue dot along the path in the miniature to set Progress by eye. The line follows as you drag, and the new value goes to After Effects when you let go.

The sliders button beside the path chip opens Progress as a number to drag or type.

A drag sets the value at the current time. On a keyframed Progress it changes the value of the keyframe at the playhead, or adds one, as typing in Effect Controls would.

Delay: one after another

By default the whole line starts and stops together. Delay makes each layer read Progress a few frames later than the layer in front of it. With Progress keyframed, the front layer sets off first and each one behind follows, then they come to rest one after another, still evenly spaced.

Delay is in frames. Set it in the sliders popover or in the Conga effect. When you change it in the panel, the dots pulse one after another at the new lag.

Delay only changes anything while Progress is keyframed. On a Progress that doesn’t move, every layer is already where it rests.