Click the sliders button beside the path chip to open the line's controls: Progress, Spacing and Delay to drag or type, and the Orient and Loop switches.

Its miniature shows a change as you drag a number. Each change is one undo step.

The same controls live in the Conga effect on the Conga null, so you can keyframe them there.

Spacing

Spacing is the gap from one layer to the next, in percent of the path’s length. A new line uses 10%, or the Spacing in the settings.

To set it by eye, press on the path between two dots in the miniature and drag along it. The gaps stretch or close evenly, with the front layer held in place.

Shift-click Line up to make a new line with a gap in pixels, 100 px unless you change Spacing with Shift. Conga turns the pixels into a percent of the path’s length when it makes the line, so after that the gap is a percent like any other.

Orient

With Orient on, each layer turns to face along the path, and the dots in the miniature grow a point showing the way they face. Conga expects art drawn facing right. If yours faces another way, set Rotation Offset in the Conga effect, such as 90 for art drawn facing up.

With Orient off, the layers keep their own Rotation as they travel.

New lines get Orient from Orient Along Path in the settings, on unless you turn it off.

Loop

With Loop on, a layer that runs past the end of the path comes round from the start, and the line can keep circling for as long as Progress keeps rising. Line up turns Loop on for a closed path and off for an open one.

With Loop off, a layer past either end waits there, so a line pushed past the end bunches up at it.

Offset

Offset in the Conga effect slides every layer along the path by the same amount without touching Progress. It’s handy for a line that should sit further along while its Progress keyframes stay as they are. It isn’t in the panel.