Spread ↔ spaces layers across and Spread ↕ spaces them down. Both measure the gaps between the layers’ visible edges, so a wide layer and a narrow one get the same space between them.

Equal gaps

Select three or more layers and click Spread ↔ or Spread ↕.

The two outer layers stay where they are. The ones between them move so every gap is the same.

Hover the tile first to see the dashed outlines of where they will go.

Evensteven works out the order from where the layers sit, left to right for Spread ↔ and top to bottom for Spread ↕. The order you selected them in doesn’t matter.

Spread only moves layers along its own axis. To line a row up and space it out, click a dot, then Spread, in either order.

An exact gap

Type the gap in pixels in the Gap field, then hold Shift and click a Spread tile. Two or more layers will do.

While Shift is held the tiles read the gap, such as 40 px ↔.

The first layer stays where it is, the leftmost or the topmost, and each of the others lines up after it with exactly that gap.

The Gap field takes 0 to 999 pixels. Drag it, or double-click it to type. In a slot too narrow for the field, right-click the target chip to find it. The gap stays until you close the panel, and Settings sets the one it starts with.

Animated layers

Spread moves every Position key of each layer, the same as aligning does. It measures the layers where they are at the playhead, so put the playhead where the layout should be even. Animated layers covers parents, separated dimensions and expressions.