Start with the Motion Dock open and a comp with a layer that has masks on it.

Add Masquerade

  1. Click Edit layout in the Motion Dock.
  2. Click an empty area of the layout and choose Masquerade.
  3. Click Exit layout mode.

Masquerade’s default slot is 10 columns wide and 9 rows tall. It works much smaller too; see Controls and slot sizes.

Select the masks

Click the layer in the timeline to convert all of its masks. To convert only some, twirl the layer open and select those masks.

Move the pointer over Convert. The line under the card says what will happen, such as 5 masks → shapes.

If it reads Select masks or shape paths, the selection has no masks in it.

Click Convert

Click Convert, or click the card itself. The card flips to its shape side and the tile shows how many paths it made, such as 5 paths.

In the timeline, a new shape layer sits directly above the masked layer. It’s named after it, such as Peak Shapes, with the same label color and the same in and out points. Inside it is one group per mask, named after the mask, holding the path and a fill in the layer’s label color.

The masks stay on the original layer. To take them off as the shapes land, hold Shift when you click; see Controls.

What carries over

  • Mask modes. When every mask adds, each becomes its own group. Once a mask subtracts, intersects or differences, the groups nest with a Merge Paths in that mode, so the shape cuts out the same area the masks did. A mask set to None comes over switched off.
  • Keys. A mask with keyframes becomes a path with the same keyframes and eases. See Keyed paths and moving layers.
  • What doesn’t. Feather, expansion, opacity and Inverted belong to masks, and shapes have nothing to put them on, so Convert leaves them behind.

Press Undo once to take it all back. Each click is one step in Edit → Undo, named Masquerade: Convert.