The three buttons above the tiles set the scope: where Retype looks for fonts, and what a replace changes. The tiles only ever show fonts in the scope, so what you see is what a drop changes.
Project covers every comp in the project, precomps included.
Comps covers the comps selected in the Project panel.
Layers covers the selected text layers in the comp that's open.
Change one comp
- Select the comp in the Project panel. Shift-click or Cmd-click to add more.
- Click Comps. The tiles show the fonts in those comps.
- Drag a font onto another. Only those comps change.
Comps reads the layers in the selected comps themselves. A precomp inside one of them isn’t included unless you select it too.
Change a few layers
Open the comp, select the text layers, and click Layers. Other layers are left alone, even ones in the same font.
Read again
Retype reads the fonts again when the pointer comes into the panel and when you come back to it, and only when something in the project changed. To read again right away, click the scope that’s already chosen.
When the tiles are empty
Select comps in the Project panel means the scope is Comps and no comp is selected there.
| Message | Cause |
|---|---|
| Select comps in the Project panel | The scope is Comps and no comp is selected. |
| Select text layers | The scope is Layers and no text layer is selected. |
| No active comp | The scope is Layers and no comp is open. |
| No text in this scope | The scope has no text layers. |
In a small slot these are shortened to Select comps, No selection, No comp and No text.
To start on a scope other than Project every time the panel opens, set Default Scope in Retype’s settings. In the smallest slots the three buttons become one; see Controls and slot sizes.