Each of the eight effects is a dot. In the row at the bottom of the preview it’s off. Anywhere above the dotted line it’s on, and where it sits shapes the animation. What each effect does to the letters is on The eight effects.

Drag an effect next to the words

Press a dot and drag it toward the words. A ribbon runs from the dot to the letter it touches, and the readout at the top says what it will do. It shows its name, its strength out of 100, the side it's on and where along the words it starts.

While you drag, the letters that go first take the effect's color. The color fades across the letters in the order they'll move.

Let go, and the preview plays the animation.

The side sets the direction

Move brings the letters in from the side it sits on, measured from the letter its ribbon touches. Above or below the words, the letters drop or rise. Off either end, they can also slide in from the left or right, or from a corner. A direction close to straight up, down, across or a 45° corner snaps to it, and the readout names it, such as from below or from above left.

Spin and Swirl turn the letters one way on the left half of the words and the other way on the right half. The side the other effects sit on doesn’t change how they look.

Closer is stronger

The distance from the dot to the letters sets the effect’s strength. Right up against the letters is 100. Far away it stops at 15, which still shows. The number in the readout is the strength.

Hold Shift while you drag and the dot moves a quarter as far as the pointer, for an exact strength. The readout adds fine while Shift is held.

Along the words sets the order

The letter nearest an effect moves first, and the rest follow in order of their distance from it.

  • First letter. Anywhere over the first 15% of the words snaps to the first letter, so the words go from left to right.
  • Middle. Near the middle snaps to the middle, so the words grow outward from the center.
  • Last letter. Over the last 15% snaps to the last letter, so they go from right to left.
  • Anywhere else starts at that point, such as 30% along.

Every effect you place is a starting point. Move on the first letter and Blur on the last letter make the words start from both ends and meet in the middle. For one clean order, put all your effects at the same spot. Two effects at the same spot sit side by side.

Drop an effect on the words

Drop a dot right on the letters and it turns into a ring. The readout says from all sides.

Move on the words sends each letter in from its own direction, all the way around. Spin or Swirl on the words turns neighbouring letters opposite ways.

Mix several effects

Drag in as many of the eight as you like. Each effect can be placed once. Their strengths add up into one animation. Move with Spin and Bounce flies the letters in turning, then springs them past their places.

The direction always comes from Move. Without Move, the letters stay where they are and only fade, grow, blur, turn or spread in place, unless Swirl carries them.

Quick ways to place an effect

Do thisWhat happens
Click an effect in the rowIt goes on under the first letter at strength 60, the standard look of that name.
Option-click an effect (Alt-click on Windows)It goes on alone under the first letter and every other effect goes back to the row.
Click a placed effectThe preview plays the animation again.
Double-click a placed effectIt goes back to the row.
Drag a placed effect below the dotted lineIt goes back to the row.
Click the clear button in the top right cornerEvery effect goes back to the row.

With no effects placed, the letters still fade in and out. That’s the plain Fade look.

Hover a placed effect

Hold the pointer over a placed dot and its tooltip repeats the readout, such as Blur 50 · from the left · first letter, with how to fine-tune it and send it back.