The preview shows Motion Fun, not my words

Typhoon reads the selection when the pointer moves onto the panel. Select your text layer, then move the pointer off Typhoon and back on. With no text layer selected, the preview shows Motion Fun.

The preview shows the first selected text layer, all on one row, and cuts long text short to what fits. Apply still animates all of it.

It says Select text layers to animate

Nothing is selected, or nothing selected is a text layer. Typhoon only animates text layers. Select one or more in the timeline and click Apply again.

It says The selected text layers are locked

Unlock them. With some locked and some not, Typhoon animates the unlocked ones and says how many it skipped.

It says No active composition

Click into a comp’s timeline or viewer, then select your text layers.

Nothing happens in the comp after Apply

The entrance plays from the layer’s in point and the exit ends at its out point. Move the playhead to the start or end of the layer to see them. If the layer starts before the comp does, its entrance is over before frame 0.

The letters fly out of the frame

Move’s distance grows with the font size, so on a big headline a strong Move can carry letters past the edge of the comp. Drag Move further from the words, or hold Shift while you drag it back a little at a time. A big Spread on long, wide words can push the end letters out too.

Letters crash into each other when they land

Bounce springs each letter past its place, and on big, tightly set type neighbouring letters can touch. Drag Bounce further from the words, or lower the overlap so fewer letters land at once.

Shift-rolling the dice changes nothing

A Shift-roll only changes the parts left to chance. Those are Scatter and the direction of each letter when Move sits on the words. Add Scatter, or drop Move on the words, to get variations.

The exit didn’t change when I applied

An end that’s switched off is left as it is on the layer. Click the dim Out to switch it back on, then click Apply. See Give the exit its own animation.

The preview plays faster or slower than my comp

The preview plays at 30 frames a second. In a comp at another frame rate, the same number of frames takes a different time. Scrub the comp to judge the real timing.

The animation got smaller or bigger after I changed the font size

Move, Blur and Spread were sized to the font when you clicked Apply. Click Apply again after a big size change.

It says Expression error

After Effects refused to run the animation on that layer, and Typhoon took it back off. Check the layer’s other expressions and animators, then try again.

I want the text back as it was

Select the layers and click Remove, or press Undo. See Change, retime or remove an animation.