The bar under the preview holds the timing.

From left to right, the bar holds letters, words or lines, the duration, the overlap, Apply and Remove.

Letters, words or lines

The first button sets what moves as one piece. Click it to cycle through Letter by letter (a T), Word by word and Line by line. Its tooltip says which is on.

Every effect works the same way on each. With words, each word flies in whole, in order from the effect’s starting point. With lines, each line of your text layer does. The preview shows all your text on one row, so with lines each line moves as one stretch of that row.

Duration

The number with an f is how long the entrance or exit takes, in frames, from 1 to 600. Drag it up or down, click its arrows, or double-click it and type. With In and Out unlinked, it’s the length of the end you’re editing.

The entrance starts on the layer’s in point. The exit ends on its out point.

Overlap

The drawing of staggered lines is the overlap. It sets how much the letters move at the same time. Each line is one letter's move.

Drag it sideways, one percent a pixel. While you drag, the top of the preview says what it comes to, such as Overlap 83% · 20 of 24f a letter. Double-click it to type a percent, then press Enter. Escape leaves it as it was.

  • 0% moves the letters one after another, each in its own slice of the duration.
  • 50%, the default, gives each letter about half the duration, so several move at once.
  • 100% moves them all at once, together, with no order.

The preview waits until you let go of a drag, then plays the new timing.

Change the timing after Apply

Apply adds a Typhoon effect to each layer, with In Duration, In Overlap, Out Duration and Out Overlap. Change them in Effect Controls and the animation follows, with no need to apply again.

The starting values for duration and overlap come from Typhoon’s settings. See Settings.