The bookmark in the preview’s top right corner opens the presets.
The top half, In and Out, holds whole animations, each an entrance with an exit made to go with it. The bottom half holds looks for one end.
Start from an entrance and exit
Click Lift off, Pop and drop or Blow through to put that entrance and exit on the panel. The preview plays them through.
- Lift off rises in from the first letter, then lifts away and blurs from the last letter.
- Pop and drop pops up from the middle with a bounce, then falls away from the first letter with a little spin. Its exit is quicker, 18 frames to the entrance’s 24.
- Blow through blows in from the left and out to the right, as if the wind carried it through.
Their two ends differ, so In and Out come unlinked.
Put a look on one end
The bottom half sets the effects of the end you’re editing, and leaves the duration and overlap alone. Its title says where it goes. It reads One for both while In and Out are linked, Just In or Just Out when they’re not.
| Look | What it is |
|---|---|
| Fade | No effects. The letters only fade. |
| Rise | Move under the first letter. The letters rise into place from half the font size below. |
| Drop | The same from above. |
| Pop | Pop under the first letter. The letters grow in from nothing. |
| Blur | Blur under the first letter. The letters come into focus. |
| Spin | Spin under the first letter. |
| Spread | Spread under the first letter. The letters close up from wide apart. |
| Squall | Move from the left with Bounce and Scatter, all at the first letter. |
| Typhoon | Move, Swirl and Scatter all at the middle, with Move on the words, so the letters spiral in from every side. |
Save your own
Click Save In and Out to keep what’s on the panel. That’s In and Out, with each end’s duration and overlap. It’s named Mix 1, then Mix 2 and so on, and listed above Save In and Out. Click it to put it back. Click the cross beside it to delete it.
Typhoon keeps your last 24 saved mixes. Saving a 25th drops the oldest. Letters, words or lines and the variation aren’t saved with a mix, so a saved mix uses whatever the panel has when you load it.
Pick up an animation from a layer
Select a text layer that already has Typhoon on it, open the presets and click From selected layer. Typhoon puts that layer’s In and Out back on the panel, with their durations and overlaps as the layer’s Typhoon effect has them now, its letters, words or lines, and its variation. The preview plays it through.
Change it and click Apply to put the new version on the layer, or select other layers and click Apply to give them the same animation. With several layers selected, it picks up from the first one that has Typhoon. With none that has it, Typhoon says No Typhoon on the selection to pick up.